Table Of Contents; Specifications; Full One Year Warranty - Craftsman 183.172540 Owner's Manual

SECTION PAGE
Warranty ........................................ 2
ProductSpecifications ...................... 2
PowerTool Safety ............................ 3
CuttingToct & AccessorySafety ......... 4
ElectricalRequirement& Safety .......... 5
CuttingTootSymbols........................ 6
SECTION PAGE
ACCSS_ .................................... 7
Carton Contents .............................. 7 - 8
Know Your Cutting Toct .................... 9 - 10
Assembly & Operation ...................... 11 - 23
Maintenance ................................... 24
Repair Parts ................................... 25 - 36
FULL ONE YEAR WARRANTY
If this Cutting Tool fails due to a defect in material or workmanship within one year of date of
purchase, Sears will at its option repair or replace it free of charge.
Return this Cutting Tool to a Sears Service Center for repair, or to place of purchase for
replacement.
This warranty gives you specific legal rights, and you may also have other dghts which may vary
from state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, IL 60179
[A WARNINGJ
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well ventilated area and work with approved safety equipment such as
those dust masks that are specially designed to filter out microscopic particles,
Motor Rating ...................... 120 V, 60 Hz, AC
Amperes ........................... 5.0 A
Two Speeds (no load) ......... 20,000 & 30,000 RPM
Motor Horsepower ...... 3/4 HP (Maximum Developed)
Weight ..................... 3 lb. 12 oz, (1.7 kg)
Maximum Disc SiZe .... 4" Diameter
J_ WARNING I
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.
This power tool is wired at the factory for 110-120 V operation. It must be connected to a 110-120 V 115 A time
delayed fuse or circuit breaker. To avoid shock or fire, replace power cord Immediately if it is worn, cut or
damaged in any way.
Before using your cutting tool, it Is critical that you read and understand these safety rules, Failure to follow
these rules could result in serious Injury to you or damage to the cutting tool.
2