Carton Contents; Unpacking And Checking Carton Contents; Available Accessories - Craftsman 183.172520 Owner's Manual

:le[o,]:l,,"[,,,_o] ;,11:1_
AVAILABLE ACCESSORIES
I,A, WARNING I
Use only accessories recommended for this cutting
tool. Follow instructions that accompany accessories.
Use of improper accessories may cause injury to the
operator or damage to the cutting tool.
Visit your Sears Hardware Department or see the Sears
Power and Hand Tool Catalog for an assortment of
accessornes recommended for use wuththis cuttnngtool
• Flex Dnve
• Rip Gunde
• I/e" Cutting Bnts
• I/s" Hobby Rotary Tool Accessones
Cutters
_" Polishers
Sanders
_' Gnndem
• Most ¼" Shank Router Bds
Use only accessories designed for this cutting tool to
avoid severe injury or tool damage.
Do not use any accessory unless you have completely
read the instructions or Owner's Manual for that
accessory.
UNPACKING AND CHECKING CARTON CONTENTS
IA WARNING I
If any part is missing or damaged, do not plug the
cutting tool into the power source until the missing or
damaged part is replaced and assembly is complete.
Carefully unpack the cuttmg too! and all its components
Compare against the "Cutting Tool Components" chart
below
NOTE: See Page 7 for illustration of components
I_, WARNING I
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the cutting tool.
CUTTING TOOL COMPONENTS
KEY I DESCRIPTION ] QTY
Inside Carrying Case
A Cutting Tool
B PrecJsuonHandle with Sole Plate
C Freehand Sole Plate Attachment
D Circle Cutter Attachment
E Cnrcle Cutter Installahon Adapter
F Plunge Router Base Attachment
G Owner's Manual
H i Carrying Case
M Collet Wrench
N Collet Wrench Holder
Front Lid Storage Compartment
I 1/8" Collet Sleeve
J 114" Collet Sleeve
K Lateral Style Drywall Cutter
L Wood / Plastic / Fiberglass Cutter
1
1
1
1
1
1
1
1
1
1
1
1
1
1
NOTE: The two most commonly used cutters are
Included with this tool (items K & L). It is important
that you use the correct cutter to ensure the most
efficient cutting action.
• Use cutter "K" with the coarser spiral for cuffing
drywall.
• Use the general purpose cutter "L" with the finer
spiral for cutting materials such as wood, plastic
and fiberglass.