Epson PowerLite 5600p User Manual page 75

You see a blue screen with the message No Signal
displayed.
Make sure the cables are connected correctly, as described in
I
Chapter 1 or Appendix A.
Try restarting your computer.
I
I If you've connected more than one computer and/or video source,
you may need to press the
control panel) or the
(on the remote control) to select the correct source. Allow a few
seconds for the projector to sync up after pressing the button.
I Make sure the
Computer 1
interface panel is set to
(for a computer using DVI video). See page 12.
Digital
If you're using a PC laptop:
Hold down the
I
Fn
display on an external monitor. It's often labelled with an icon
such as or it may be labelled
laptop's manual or online help for details. On most systems, the
key lets you toggle between the LCD screen and the
projector, or to display on both at the same time. Allow a few
seconds for the projector to sync up after pressing it.
Depending on your computer's video card, you might need to use
I
the Display utility in the Control Panel to make sure that both the
LCD screen and external monitor port are enabled. See your
computer's documentation or online help for details.
If you're using a PowerBook:
1. From the Apple menu, select
Monitors and Sound.
2. Click the
Arrange
3. Drag one monitor icon on top of the other. This lets you
display on the projector screen as well as the LCD screen.
4. If the Arrange option isn't available, click the
5. Select one of the listed
moment for the projector to sync up.)
or
Computer Video
,
Comp1 Comp2/YCbCr
selector switch on the projector's
(for standard computer video) or
Analog
key and press the function key that lets you
CRT/LCD
Control Panels
icon.
resolutions. (It may take a
Simulscan
button (on the
, or button
Video
. Check your
, then click
icon.
Monitor
Solving Problems
69