Craftsman nextec 320.10005 Operator's Manual page 11

12.0-volt lithium-ion cordless led worklight
Table of Contents

Advertisement

Q
Water entering the charger will increase the risk of electric shock.
Use of an attachment
not recommended
or sold by the battery-charger
manufacturer
may result in a risk of fire, electric
shock or injury
to persons.
Do not abuse the cord or charger.
Never use the cord to carry the charger.
Do not pull the charger cord to disconnect the plug from the electrical
receptacle. Damage to the cord or charger could occur and create an electric
shock hazard. Replace damaged cords immediately.
Make sure that the cord is located so that it will not be stepped
on,
tripped over, come in contact
with sharp edges or moving parts, or
otherwise
subjected
to damage
or stress. This will reduce the risk of
accidental falls, which could cause injury and damage to the cord, which
could then result in electric shock.
Keep the cord and charger from heat to prevent
damage to housing or
internal parts.
Do not allow gasoline,
oils, petroleum-based
products,
etc. to come
in contact with plastic parts. These materials contain chemicals that can
damage, weaken, or destroy plastic.
An extension
cord
should
not be used
unless
absolutely
necessary.
Use
of an improper
extension
cord could
result in a risk of fire and electric
shock.
If an extension
cord must be used,
make
sure that:
The pins on plug of extension
cord are the same number, size and shape as
those of the plug on charger.
The cord is properly wired and in good electrical
condition
The size is large enough for AC ampere rating of charger as specified
below:
The Cord Length (Feet)
Cord Size (AWG)
NOTE: AWG = American
Wire Gauge
25'
50'
100'
6
16
16
Do not operate the charger with a damaged
cord or plug, which could
cause shorting and electric shock. If damaged, have the charger repaired or
replaced by an authorized
service technician
at a Sears Service Center.
Do not operate the charger
if it has received a sharp blow, been dropped,
or has otherwise been damaged in any way. Take it to an authorized service
technician at Sears Service Center for an electrical
check to determine if the
charger is in good working order.
Do not disassemble
the charger.
Take
it to an authorized
service
technician
at a Sears
Service
Center
when
service
or repair is required.
Incorrect
reassembly
may result in a risk of electric
shock or fire.
Unplug the charger from the electrical
outlet before attempting any
10005
Manual_Revised_08-0724
Page 11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents