Spark Plug; Rear Deflector - Craftsman 917.388300 Owner's Manual

• Clean the inside of the cover and the
collar to remove any dirt accumulation.
• Insert new filter into cover.
• Put air filter cover and filler into collar
aligning the tab with the slot.
• Push in on cover and tum clockwise to
tighten.
Collar Clip
Tum
counter--
clockwise to
remove
clockwise
Air filter cover to tighten
MUFFLER
Inspect and replace corroded muffler as it
could create afire hazard and/or damage.
SPARK PLUG
Change your spark plug each year to
make your engine start easier and run
better. Set spark plug gap at .030 inch.
CLEANING
IMPORTANT: For best performance, keep
"mower housing free of built---up grass
and trash. Clean underside of mower
housing after each use.
CAUTION: spark plug wire
Disconnect
from spark plug and place wire where it cannot
come in contact with the spark plug.
• Turn lawn mower on its side. Make sure
air filler and carburetor are up. Clean
the underside of your lawn mower by
scraping to remove build--up of grass
and trash.
• Clean engine often to keep trash from
accumulating. A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• We DO NOT recommend using a
garden hose to clean lawn mower
unless the electdcal system, muffler, air
filter and carburetor are covered to
keep water out. Water in engine can
result in shortened engine life.
&CAUTION: Before performing any
service or adjustments:
• Release control bar and stop engine.
• Make sure the blade and all moving
parts have completely stopped.
• Disconnect spark plug wire from spark
plug and place where it cannot come in
contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your lawn mower, is
provided to minimize the possibility that
objects will be thrown out the rear of the
lawn mower into the operator's mowing
position.
If the rear deflector becomes damaged, it
should be replaced.
TO ADJUST HANDLE
The handle on your lawn mower has
three (3) height positions - adjust to height
that suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of
the three height adjustment holes.
High
Med._
Low 1"=
._ Handle pin
"_ \ 3-position
Handle
i! \ \ adjustment
\ bracket
13