Craftsman 315.175170 Operator's Manual page 23

BRUSH BRUSH
CAP ASSEMBLY
PLUNGE
LOCK LEVER
I BRUSH
ASSEMBLY
BRUSH
CAP
Fig. 24
PLUNGE LOCK LEVER
See Figure_ 25 - 27.
After extended use, the plunge lock may wear. )S = this
happens, you can easily adjust the lever.
To ad)ust plunge lock lever:.
• Unplug the muter.
• Make sure lever is In locked position.
• Remove the screw supporting the plunge lock lever.
• Remove the lever.
• Place the lever back in the odginal Cookedposition.
• Replace the screw.
• Check for free plunge with lever rotated to unlocked
position.If muter does not plunge freely, reposition
lever.
SCREW
PLUNGE LOCKLEVER SHOWN
IN ORIGINAL LOCKED POSITION
Fig. 26
Fig. 27
PLUNGE LOCK LEVER SHOWN
AFTER EXTENDED WEAR
Fig. 25
23