Table of Contents
Advertisement
WARNING:
C utter continues to rotate after the
router has been turned off. To avoid in{ury, w ait until
the cutter has come to a complete stop before re-
moving router from the workplace.
OPERATING
THE ROUTER
See Figures 14- 16.
When routing straight cuts across stocK,clamp e straight
edge to the workpiece to use as a guide. Position the
straight edge parallel to the fine of cut and offset the
distance between the cutting edge of the CUtterand the
edge of the muter base. Hold the reuter base against the
straight edge and rout the groove.
When muting s groovewider then the diameter of the cut-
tar, clamp a straight edge on both sides of the cut fines.
Position both guides parallel to the desired rlneof cut and
spaced equal distances from the desired edges of the
groove. Rout along one guide, then reverse direction and
rout along the other guide. Clean out any remainingwaste
in the center of the groove.
EDGE ROUTING
•
Place the muter on the edge of the workpiece without
the cutter contacting the workpiece.
•
Turn muter on and let the motor build to full speed.
•
Graduallyfeed the cutter into the workplace.
•
Upon completion of the cut, turn the muter off and let
the cutter come to a complete stop besom removing
the reuter _om theworkpiece.
CLAMP
STRAIGHT
EDGE
WORt(PIECE
Fig. 15
CUTTER EXTENDED BELOW SOBBASE
Fig. 14
17
Hide quick links:
Advertisement
Table of Contents
