Tools Required For Assembly; To Remove Tractor From Carton; Before Rolling Tractor Off Skid - Craftsman EZ3 917.273030 Owner's Manual

Your new tractor has been assembled at the factory with exception of those parts'left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary tQ insure proper tightness. Review the video cassette before you begin.
TOOLS REQUIRED FOR
ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need
are listed below_
(1) 9/16" wrench
(1) 1/2" wrench
(1) 3/4." Socket wl
drive rachet
(1) Pliers : (1) Phi!lips, Screw-
(1) Utility knife driver
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posi-
tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTOI_ i
o Remove all accessible loose parts and
parts boxes fromshipping carton (See
page 6).
o Cut, from top to bottom, along lines on
all four corners of shipping carton, and
lay panels flat. i
° Remove mower and package materials°
° Check for any additional loose parts or
boxes and remove.
BEFORE ROLLING TRACTOR OFF
SKiD
ATTACH STEERING WHEEL
° Remove hex bolt, lock washer and large
flat washer from steering shaft.
° Position front wheels of the tractor so
they are pointing straight forward.
° Slide the steerin_t sleeve over the steer-
ing shaft.
I
° Align tabs and press steering sleeve
extension into bdttom of steering wheel.
° Position steering wheel so cross bars
are horizontal (left to right) and slide
onto steering wheel adapter.
= Secure Steering wheel to steering shaft
with hex bolt, lock washer and large flat
washer previously removed. Tighten
securely.
° Snap steering wheel insert into center
of steenng wheel.
o Remove protective materials from trac-
tor hood and gnll_;
"_----" Wheel Insert
.._ Hex Bolt
Lock Washer
Large Flat
Washer
Steering
Steering Wheel
Wheel Adapter
Steering _ Tabs
Sleeve t
Extension
Shaft ,_,1
Steedng
Sleeve
_MPORTANT- Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
TO ROLL TRACTOR OFF SKiD (See
Operation section for location and
function of controls)
• Press lift lever plunger and raise attach-
ment lift lever to its highest position.
= Release parking brake by depressing
clutch/brake pedal.
o Place gearshift lever in neutral (N) posi-
tion.
° Roll tractor forward off skid.