Advertisement
be thrown into eyes and face and
cause blindness or other serious injury.
Before trimming, bring engine to a
speed sufficient to cut material to be
trimmed.
Do not run the engine at a higher speed
than necessary. The cutting line will cut
efficiently when the engine is run at less
than full throttle. At lower speeds, there
is less engine noise and vibration. The
cutting line will last longer and will be
less likely to "weld" onto the spool.
Always release the throttle trigger and
allow the engine to return to idle
speed when not cutting.
HOW TO STOP YOUR UNIT
• Release the throttle trigger.
• Move ON/OFF switch to the OFF
position.
CUTTING
METHODS
,I_WARNING:
Use minimum
speed and do not crowd the line when
cutting around hard objects
(rock,
gravel, fence posts, etc.), which can
damage
the trimmer head, become
entangled
in the line, or be thrown
causing
a serious hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum
line wear by not
crowding
the line into the cutting
area. The right and wrong ways are
shown below.
Tip of line does the
Line crowded into
wor__
Right
Wrong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences.
• For trimming or scalping,
use less
than full throttle to increase
line life
and decrease
head wear, especially:
• During light duty cutting.
• Near objects around which the line
can wrap such as small posts,
trees or fence wire.
TRIMMING
- Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact
with vegetation.
Do not force
trimmer line into work area.
Trimming
3 inches
(8 crr
above ground
SCALPING
- The scalping technique
removes unwanted vegetation down to
the ground. Hold the bottom of the trim-
mer head about 3 inches (8 cm) above
the ground and at an angle. Allow the
tip of the line to strike the ground
around trees, posts, monuments,
etc.
This technique increases line wear.
Scalping
MOWING
- Your trimmer is ideal for
mowing in places conventional
lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing
the head into
the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING - The fanning action of the
rotating line can be used to blow away
loose debris from an area. Keep the line
parallel to and above the area surface
and swing the tool from side to side.
13
Advertisement
