COMPANION 172.21199 Operator's Manual page 39

CUTTING CROWN MOLDING cont.
Bevel
Angle Setting
33.85 °
33.85 °
33.85 °
33.85 °
Type of Cut
Left side, inside 90° corner
1. Top edge of moldingagainst fence
2. Miter table set right 31.62 °
3. Save left end of cut
Right side, inside 90 ° corner
1. Bottom edge of molding against fence
2, Miter table set left 31,62 °
3, Save left end of cut
Left side, outside 90 ° corner
1. Bottomedge of moldingagainst fence
2. Miter table set left 31.62 °
3. Save right end of cut
Right side, outside 90 ° corner
1.Top edge of molding against fence
2. Miter table set right 31.62 °
3. Save right end of cut
CUTTING WARPED MATERIAL (See Figures 32 - 33)
When cutting warped material, ALWAYS make sure that it is positioned on the
miter table with the convex side against the fence, as shown in Figure 32.
If the warped material is positioned the wrong way, as shown in Figure 33,
it will pinch the blade near the end of the cut.
Fig. 33
Wrong
/ WARNING:
To avoid kickback and to avoid serious personal injury NEVER
position the concave side of bowed or warped material against the fence.
39