Service Safety - COMPANION 172.21199 Operator's Manual

ADDITIONAL SPECIFIC SAFETY RULES FOR MITER SAWS cont.
WEAR YOUR
,AkWARNING:
The operationof any saw can result in foreign
objects being thrown intoyour eyes, whichcan result in severe eye
damage. Before beginningpower tooloperation,ALWAYS wear
safety goggles or safety glasses with side shieldsand a full face
shield when needed.We recommenda Wide Vision Safety Mask for
use over eyeglasses or standardsafety glasses with side shield, both
availableat Sears Retail Stores.
SERVICE SAFETY
1. If any part of this table saw is missing or should break, bend, or fail in any way;
or should any electrical component fail to perform properly:
ALWAYS shut off the power switch and remove the miter saw plug from the power
source and have the missing, damaged or failed parts replaced BEFORE resuming
operation.
2. Tool service must be performed only at a Sears Service Center. Service or
maintenance performed by unqualified personnel could result in a risk of injury.
3. When servicing a tool, ALWAYS use only identical replacement parts. Follow
instructions in the Maintenance Section of this manual. Use of unauthorized parts or
failure to follow Maintenance Instructions may create a risk of electric shock or injury.
The label on your tool may include the following symbols.
V ........................................................................................... Vo Its
A ........................................................................................... Amperes
Hz ......................................................................................... Hertz
W .......................................................................................... Watts
rain ....................................................................................... Minutes
,--..,........................................................................................ Alternating current
......................................................................................... Direct current
no ........................................................................................ No-load speed
[] .......................................................................................... Class II construction
.../min ................................................................................... Revolutions or
reciprocation per minute
Z_ ......................................................................................... Indicates danger, warning
caution. It means attention!!!
Your safety is involved.
IMPORTANT! READ ALL INSTRUCTIONS
11