Craftsman EZ3 917.258863 Owner's Manual page 25

SERVHCE
........................ ....._..i,,i ,
ADJUSTMENTS
TO REPLACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the backside of the
grill.
° Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill,,
° Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorty,stop running, or prevent it from starting.
o Check wiring° See electrical wiringdiagram in Repair
Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotiveotypeplug-in fuse° The
fuse holder is located behind the dash.
TO ADJUST ATTACHMENT LIFT SPRING
(See Fig. 31)
• While holdingspring bushing with wrench, loosen jam
nut.
° Turn adjustment bolt clockwise to extend spring and
reduce lift effort (for heavier attachments)°
° Turn adjustment bolt counterclockwisefor lighter at-
tachments.
• Retighten jam nut against spring bushing.
IMPORTANT: DO NOT ADJUST FOR MAXIMUM SPRING
TENSION WHEN USING LIGHT ATTACHMENTS SUCH
AS A MOWER° ADJUST LIFT LEVER SPRING TO AID IN
LIFTING ATTACHMENT. DO NOT OVERPOWER SPRING.
WHEN REMOVING ATTACHMENT, ALWAYS ADJUST
SPRING TENSION TO ITS LOWEST POSITION°
ADJUSTMENT
SPRING BUSHING
JAM NUT
ATTACHMENT
LIFT SPRING
/
FIG. 31
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
° Raise hood.
. Unsnap headlight wire connector,
° Stand infront oftractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
° To replace, reverse above procedure,
HOOD
HEADLIGHT
WIRE
CONNEC_ON
FIG, 32
25