Craftsman 917.272234 Owner's Manual page 15

2o hp electric start 48" mower 6 speed transaxle lawn tractor
Table of Contents

Advertisement

The cutting height range i s approxi-
mateiy 1-1/2 t o 4".The heights are
measured
from the ground totheblade
tipwith the engine notrunning. These
heights areapproximate
and may vary
depending
upon soil conditions, height of
grass and types of grass being mowed.
• The average lawn should be cut to
approximately 2-1/2. inches during the
cool season and to over 3 inches
during hot months, For healthier and
better looking lawns, mow often and
after moderate growth.
• For best cutting performance, grass
over 6 inches in height shouldbe
mowed twice. Make the first cut
relatively high; the second to desired
height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted
when they are slightlyoff the ground
when mower is at the desired cutting
height in operating position. Gauge
wheels then keep the deck in proper
positionto help prevent scalping in most
terrain conditions.
NOTE: Be sure tractoris on a flat level
surface.
1. Lower mower and adjust mower to
desired cutting height.
2, Remove retainer spring and clevis pin
which secure each gauge wheel bar.
3. Lower gauge wheels to ground. Raise
gauge wheels slightly to align holes in
bracket and gauge wheel bar and
insert clevis pin. Gauge wheels
should be slightly off the ground.
4. Replace retainer spring into clevis pin.
5. Besure all gauge wheels are in the
same setting.
IMPORTANT: Be sure to readjust gauge
wheels if you change the cutting height
of the mower deck.
Retainer
Spring
Clevis
Pin
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt by
the operator to leave the seat with the
engine running and the attachment clutch
engaged will s hut off the engine.
1. Select desired height of cut.
2. Start mower blades by engaging
attachment clutch control
TO STOP MOWER BLADES -
disengage attachment clutch control.
_I, CAUTIONt Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector
shield inplace.
Attachment Clutch
Attachment Lift Lever
Switch PuU Out To
High Position
"Engage"
_.----Low
Position
Deflector
Shield
PushIn To
"Disengage"
1"O OPERATE
ON HILLS
_,CAUTION:
Do not drive up or down
hills with slopes greater than 15° and do
not drive across any slope,
• Choose the slowest speed before
starting up or down hills.
• Avoid stopping or changing speed on
hills.
• If slowing isnecesaa_/, move throttle
control lever to slower position.
• If stopping is absolutely necessary,
push clutch/brake pedal quickly to
brake position and engage parking
brake.
• Move gearshift lever to 1st gear, Be
sure you have allowed room for tractor
to rollslightly as you restart movement.
• To restart movement, slowly release
parking brake and clutch/brake pedal.
• Make all turns slowly.
TO TRANSPORT
• Raise attachment lift to highest position
with att_chreent lift control.
• When pushing or towing your tractor,
be sure gearshift lever is in neutral (N)
position.
• Do not push or tow tractor at more than
five (5) MPH.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents