Maintenance - Craftsman 358.794201 Instruction Manual

1. Move throttle lever to the ,r_ posi-
tion.
2. Move the choke lever to the
CHOKE OFF position.
3. Pull starter handle sharply until en-
gine runs.
NOTE: If engine does not run after 5
pulls, repeat STARTING A COLD ENGINE
procedure.
CUSTOMER RESPONSIBILITIES
STARTING A FLOODED ENGINE
Flooded engines can be started by plac-
ing the choke lever in the CHOKE OFF
position and the throttle lever in the 'f_
position; then, pull the starter handle
sharply to clear the engine of excess fuel.
This could require pulling the starter han-
dle many times depending on how badly
the unit is flooded. If the unit still does not
start, refer to TROUBLESHOOTINGTABLE
or call 1-800-235-5878.
WARNING: Disconnect the spark plu_
service, or adiustments.
CARE & MAINTENANCE TASK
Check for loose fasteners and parts
Check for damaged or worn parts
Inspect and clean unit and labels
Clean air filter
Replace spark plug
GEN ERAL RECOMMEN DATIONS
The warranty on this unit does not cov-
er items that have been subjected to
operator abuse or negligence. To re-
ceive full value from the warranty, the
operator must maintain unit as
instructed in this manual. Various ad*
justments will need to be made period-
ically to properly maintain your unit.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
CHECK FOR DAMAGED OR
WORN PARTS
Contact your Sears Service Center for
replacement of damaged or worn
parts.
• Throttle Lever - Ensure throttle lever
functions properly by moving the
throttle lever to the STOP position.
Make sure engine stops; then restart
engine and continue.
• Fuel Tank - Discontinue use of unit if
fuel tank shows signs of damage or
leaks.
INSPECT AND CLEAN UNIT AND
DECALS
• After each use, inspect complete unit
for loose or damaged parts. Clean
the unit using a damp cloth with a
mild detergent.
before performing maintenance,
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
Cleaning the air filter:
A dirty air filter decreases engine per-
formance and increases fuel consump-
tion and harmful emissions. Always
clean after every 5 hours of operation.
1. Clean the cover and the area
around it to keep debris from falling
into the carburetor chamber when
the cover is removed.
2. Remove parts as illustrated.
NOTE: Do not clean filter in gasoline
or other flammable solvent. Doing so
can create a fire hazard or produce
harmful evaporative emissions.
3. Wash the filter in soap and water.
4. Allow filter to dry.
5. Apply a few drops of oil to the filter;
squeeze filter to distribute oil.
6. Replace parts.
-7-