Craftsman EZ3 917.259531 Owner's Manual page 25

SERVICE ADJUSTMENTS
POSITIVE TERMINAL NEGATIVE TERMINAL
D
BATTERY
POSITIVE TERMINAL NEGATIVE TERMINAL
FIG, 3'1
TO REPLACE HEADLIGHT BULB
Raise hoe&
o Pull bulb holder out of the hole in the backside of the
grill,
o Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill
= Close hood°
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring, See electrical wiring diagram in the
Repair Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotive-type plug-in fuse The
fuse holder is located behind the dash
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig, 32)
= Raise hood°
° Unsnap headlight wire connector.
= Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
° To replace, reverse above procedures.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 32
ENGUNE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as follows:
° With engine not running, move throttle control lever
from slow (,,_) to choke (N) position, Slowly move
lever from choke
(1\I)
to fast (,_) position.
° Checkthat holes"A" in governor control lever and hole
in governor plate line-up If holes "A" are not alinned
loosen clamp screw and move throttle cable unhl holes
are aligned. Tighten clamp screw securely.
GOVERNOR
CONTROLLEVER
GOVERNOR
CONTROLPLATE
HOLES"A" CLAMP THROTTLE
SCREW CABLE
FIG. 33
25