Craftsman EZ3 917.259531 Owner's Manual page 21

SERVBCF= ADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
o
o
Q
o
o
o
Depress clutch/brake pedal fully and set parking brake.
Place motion control lever in neutral (N) position.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key "OFF" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRACTOR
TO REMOVE MOWER (See Fig. 21)
Mower willbe easier to remove from the right side oftractor.
• Place attachment clutch in "DISENGAGED" position_
° Move attachment lift lever forward to lower mower to its
lowest position..
° Roll belt off engine pulley.
o Disconnect clutch rod from clutch lever by removing
retainer spring.
Disconnect anti-sway bar from chassis bracket by
removing retainer spring.
o Disconnect suspension arms from rear deck brackets
by removing retainer springs.
° Disconnect front links from deck by removing retainer
spnngs,
= Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR,
REMOVE THE FRONT LINKS
TO INSTALL MOWER
(See Fig. 21)
° Raise attachment lift lever to its highest position
° Slide mower under tractor with discharge guard to right
side of tractor.
= Lower lift lever to its lowest position.
= Install mower in reverse order of removal instructions..
CLUTCH I
RETAINER
SPRING
ANTI-SWAY BAR
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 21
21