Advertisement
Your abrasive cut-off machine has been shipped
completely
assembled.
• Remove all loose parts from the carton.
•
Remove the packing materials from around your
machine
• Carefully Ii_ the cut-off machine from the carton
and place it on a level work surface. This is a
heavy Ioo1. To avoid back injury, get help when
needed,
• Do not discard the packing materials
until you have
carefully inspected the machine, identified all loose
parts, and satisfactorily operated your new abra-
sive cut-off machine.
•
Your cut-off machine
has been shipped with the
machine
a.rm looked in the down position. To
release the arm. push clown on top of the machine
arm and pull the arm lock lever. See Figure 3.
•
Hand pressure should remain on the machine arm
to prevent sudden rise upon release of the arm
lock lever.
• Examine all parts to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to
plug in the power cord and turn the switch on untilthe
damaged or missing parts are obtained and are
installedcorrectly.
._
WARNING:
If any parts are missingdo not
operate your cut-off machine untilthe missing
parts are replaced. F_tura to do so could result
in possibleserious injury.
LOOSE
PARTS
LIST
The following itemsare includedwith your Abrasive
Cut-off Machine;
[] 14 in. (356 ram) - Abrasive Wheel- installed on
Machine
• Wheel Wrench - 8 mm Hax Kay - Stored on
Machine
•
Operator'sManual
Wheel Type
Wheel Diameter
Wheel Thickness
Wheel Arbor Hole
Overall Wheel Size
No Load Speed
Rating
Input
Net Weight
Reinforced Abrasive Wheels
Fence Angle
14 in. (356 ram)
Right
1/8 in. (3,2 ram)
- • Left
1.0 in. (25,4 ram)
14in. x1/ain, xtin.
356 mm x 3,2 mm x 25.4 mm
3300 RPM
120 Volts, AC/DC
15 Amp
65 Ibs. (30 kg.)
Vise Clamp Angle
Right or Left
Maximum CuttingCapacities:
45 U
0 o
45 °
Round Pipe
Angle Stock
Flat Metal Stock
5 in. (127 mm) OUtside diameter
6-t/2 in. wide x 3-5/16 in. tall
165 mm wide x 84 mm tall
8-1/16 in. wide x 2-5/16 in. tall
205 mm wide x 59 mm tall
,_
WARNING:
This cut-off machine has been
designed for cuffing metals, using reinforced
abrasive cut-off wheels only, Do not remove the
wheel, install a steel blade, and attemptto cut
other types of materials such as wood, masonry.
etc. Attemptingto cut these othertYpes of
materials could cause an accident resulting in
possible serious personalinjury.
_,
WARNING:
Do not attempt to modify this tool
or create accessories not recommendedfor use
with this tool. Any such alteration or modification
is misuse and could resultin a hazardous
conditionleading to possiblesedous personal
injury.
7
Advertisement
