Gigabyte GA-MA770-DS3P User Manual page 76

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup .
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Ensure OnChip SATA Controller is enabled under Integrated Peripherals. To create RAID, set
OnChip SATA Type to RAID. Then enable the SATA channels with hard disks that you want to use for
RAID (for example, OnChip SATA Port4/5 Type controls the SATAII4/5 connector)(Figure 1).
OnChip IDE Channel
Onboard 1394 Function
Onboard LAN Function
Onboard LAN Boot ROM
 SMART LAN
OnChip SATA Controller
OnChip SATA Type
OnChip SATA Port4/5 Type
Onboard Audio Function
OnChip USB Controller
USB EHCI Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move
Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
GA-MA770 Series Motherboard
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[RAID]
[As SATA Type]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
F10: Save
Figure 1
- 76 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults