Epson TM-T85 Operator's Manual page 83

x0 = [(xL + xH
y0 = [(yL + yH
dx = [dxL + dxH
dy = [dyL + dyH
The printing area is set as shown in the figure below.
[Notes] • If this command is input in standard mode, the printer executes
only internal flag operation. This command does not affect
printing in standard mode.
• If the horizlntal or vertical starting position is set outside the
printable area, the printer stops command processing and
processes the following data as normal data.
• If the printing area width or height is set to 0, the printer stops
command processing and processes the following data as normal
data.
• This command sets the position where data is buffered to the
position specified by ESC T within the printing area.
• If (horizontal starting position + printing area width) exceeds the
printable area, the printing area width is automatically set to
(horizontal printable area - horizontal starting position).
• If (vertical starting position + printing area height ) exceeds the
printable area, the printing area height is automatically set to
(vertical printable area - vertical starting position ).
• The horizontal and vertical motion unit are specified by GS P.
Changing the horizontal or vertical motion unit does not affect the
current printing area.
• The GS P command can change the horizontal (and vertical)
motion unit. However, the value cannot be less than the minimum
horizontal movement amount, and it must be in even units of
minimum horizontal movement amount.
• Use the horizontal motion unit (x) for setting the horizontal
starting position and printing area width, and use the vertical
motion unit (y) for setting the vertical starting position and
printing area height.
256) (horizontal motion unit)]
256) (vertical motion unit)]
256) (horizontal motion unit)]
256) (vertical motion unit)]
Commands 5-25