Epson TM-T85 Operator's Manual page 75

Decimal
[Range] 0 n
[Description] Sets the line spacing to [n x vertical or horizontal motion unit]
inches.
[Notes] • The line spacing can be set independently in standard mode and
in page mode.
• The horizontal and vertical motion unit are specified by GS P.
Changing the horizontal or vertical motion unit does not affect the
current line spacing.
• The GS P command can change the horizontal (and vertical)
motion unit. However, the value cannot be less than the minimum
vertical movement amout, and it must be in even units of the
minimum vertical movement amount.
• In standard mode, the vertical motion unit (y) is used.
• In page mode, this command functions as follows, depending on
the starting position of the printable area:
• The maximum line spacing is 40 inches. When the setting value
exceeds the maximum, it is converted to the maximum
automatically.
[Default] n = 60 (1/6 inch)
[Reference]
ESC 2, GS P
ESC = n
[Name] Set peripheral device
[Format] ASCII
Hex
Decimal
[Range] 0 n
[Description] Selects the device to which the host computer sends data, using n as
follows:
• Each bit of n is used as follows:
Bit Off/On
0 Off
On
1 -
27 51
255
When the starting position is set to the upper left or lower right
of the printable area using ESC T, the vertical motion unit (y) is
used.
When the starting position is set to the upper right or lower left
of the print able area using ESC T, the horizontal motion unit (x)
is used.
ESC =
1B 3D
27 61
255
Hex Decimal
00 0
01 1
- -
n
n
n
n
Function
Printer disabled.
Printer enabled.
Undefined.
Commands 5-17