To Replace Fuse; To Replace Headlight Bulb; Interlocks And Relays; To Remove Hood And Grill - Craftsman 917.255430 Owner's Manual

TO REPLACE FUSE
Replace with 30 amp automotive-type ptug-in fuse. The
fuss holder is located in the engine compartment, directly
in front of the dash
TO REPLACE HEADLIGHT BULB
• Raise hood
• Pull bulb holder out of the hole in the backside of the
grill.
• Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting,
• Check wiring. See electrical wiring diagram in Repair
Parts section of this manual.
TO REMOVE HOOD AND GRILL (See Fig. 27)
• Raise hood.
• Unsnap headlight wire connector°
• Stand in front of tractor, Grasp hood at sides, tilt
forward and lift off of tractor.
• To reinstall, slide hood pivot brackets into slots in
frame_
• Reconnect headlight wire connector and close hood.
HOOD
HEADLIGHT
WIRE
CONNECTOR
FIG. 27
22