Advertisement
TOREMOVE B LADE
See Figure 6.
•
Remove batter/pack from saw,
WARN ING: Failure to remove battery back from
sew could result in accidental startingcausing
possiblesedous personal injury.
m Remove blade wrenchfrom storagearea. See/:?gum 1.
•
Position sew as shown in figure 5, depress spindlelock
button, and remove blade screw.
Note; Turn blade screw clockwiseto remove.
M Remove outer bladewasher.See F/gum 5.
Note: Bledo can be removed at this point.
DEPRESS SPINDLE
LOCKBUTFON
LOOSEN
SCREW
BLADE
WRENCH
TO
TIGHTEN
Fig. 6
TO INSTALL BATTERY PACK
See Figure 7.
Note: Battery pack is shipped in a low charge condition,
Therefore, it must be charged pdor to use. Refer to page
10, =CHARGING BATTERY PACK" for charging
instructions,
•
Place battery back in your sew. Align raised db on
battery back with groove inside sew, then slide battery
pack in saw as shown in figure 7,
•
Make sure the latches on each side of your battery
back snap into place and battery pack is secured in
saw before beginningoperation,
CAUTION: When placing battery back in your sew,
be sure raised fib on battery back aligns with groove
inside saw end latches snap into place properly,
Improper assembly can cause damage to sew and
battery peck.
LATCHES
BATrERY PACK
Fig. 7
BLADE GUARD SYSTEM
The lower blade guard attached to your tdm sew is
there for your protection and safety. It should never be
altered for any mason. If it becomes damaged or
begins to mtum slow or sluggish, do not operate your
sew until the damage has been repaired or replaced.
Always leave guard in operating position whon using
SaW.
_k
DANGER: When sewing through workpiese,lower
blade guard does not cover blade on the underside of
workpiece,Since blade is e_pesed on undersideof
workpiece,keep handsand fingers away from cutting
area. Any part of your body coming in contact with
moving blade will resultin serious injury,
See Figure 8.
LOWERBLADEGUARD
IS IN UP POSITION
WHEN MAKINGA CUT
BLADE EXPOSED ON
UNDERSIDE O FWORKPIECE
Fig. 8
Never use sew when guard is not obamtingcorrectly.
Guard shouldbe checked for correct operation before
each use. If you drop your sew, checkthe lower blade
guard and bumperfor damage at all depth settingsbefore
reuse. Note: The guard is operatingcorrectly when it
moves freely and readilyratums to the closed position. If
for any reason your lower blade guard does notclose
freely, take itto the nearest Sears Parts and Repair Center
for service before using,
13
Advertisement
