Craftsman 875.59750 Owner's Manual page 4

Deluxe Service Cart
Padded Work Surface, L ocking Top, Dual L ocking Drawer
Locking Pry Bar Holder and SideWork Shelf
@
@
Improper assembly can cause broken parts.
Read Instructions before assembling.
Broken parts can cause injury.
Units can tip or strike you.
Do not open more than one loaded drawer at a time.
L@
Close lid and lock drawers before moving.
Do not step in or on drawers.
Secure units together with fasteners.
Do not exceed 150 Ib load capacity per cart tl_]_
Apply brakes on locking casters when not moving.
Tipping of storage unit or unit striking you can cause injury
and damage,
Component edges can cut or pinch.
• Wear gloves when lifting by edges.
• Keep feet and fingers clear of edges
when stacking, hanging, or moving units.
• Move cart slowly when loaded, avoid
cracks, holes and other floor irregularities.
• Do not pull; push to move.
Unit edges can cause injury.
Particles may fly during assembly
Wear safety goggles, assembler and bystanders.
Flying particles can cause eye injury.
TOOLS NEEDED FOR ASSEMBLY:
#2 or #3 Phillips Screwdriver _--- _
10mmWrench _
Hardware Included for
Assembly:
Bolt Nut Flat Washer Lock Washer
@ ©
8 8 16 8
Screw
i¸
1
ASSEMBLY INSTRUCTIONS
Step 1. On a clean surface to protect against marring
the cart surface, carefully lay the pre-assembled Padded
Locking Top and Dual Locking Drawer Unit (#1) on its
back. Unlock top and carefully lay the top back on the floor.
Step 2. Slide the C hrome Legs (#2) into the square holes on
each side of the Locking Top until the holes nearest the top
portion of the Chrome Legs are aligned with the bolt holes
in the Locking Top. However, do not install bolts at this
time. Next, determine on which side of the Service Cart the
Pry Bar Holder (#12) and the Side Work Shelf (#11) will be
mounted. (Each may be mounted on either side.)
Step 3. Open the Locking Pry Bar Holder (#12) and, with the lip on the back of
the Pry Bar Holder resting on top of the Locking Top frame, align bolt holes with
the bolt holes in Locking Top and Legs. As shown in the diagram, insert two bolts
with one flat washer each through Pry Bar Holder, Locking Top and Legs and
fasten using one flat washer, lock washer and nut on each bolt. Tighten securely.
Return Pry Bar Holder to the locked position before proceeding.
Step 4. On opposite side of cart, mount the Side Work Shelf (#11) in the same
manner as outlined in Step 3. Once fasteners are tightened securely, open Side
Work Shelf and lock into place by resting the bottom edge of support plate in the
lip portion of the mounting plate.
Step 5. Slide Bottom Tray (#10) onto Chrome Legs (#2), align bolt holes and install fasteners
in the same sequence as in Step 3, but do not tighten bolts until all four have been installed. Then, tighten all fasteners securely.
Step 6. Insert one caster (#3 & #4) into each of the four plastic inserts.
NOT E : Insert the two locking casters (#3) at the same end of the cart.
You are now ready to set the assembled Service Cart upright onto its wheels.
10
Bolt
\
Flat
Washer