Craftsman 113.228360 Owner's Manual page 21

3. Check and be sure that inside of headstock and
tailstock spindles are clean. Insert spur center into
headstock spindle and cup center into taitstock
spindle.
NOTE" Do not drive or hammer spur center and
oup center into spindles as removal may be difficult.
Use a soft hammer or block of wood and give them
a gentle tap.
4. To remove spur center from spindle push motor
cover to left, hold the spindle pulley with one hand,
and using a wrench, turn the hex nut coun-
terclockwise until center is ejected.
If this method doesn't eject spindle, remove motor
cover (see section covering "Mounting and As-
sembling Headstock"). Insert a 1/4" dowel rod or
brass rod through hole in spindle. Hold spur center
with one hand and tap dowel or rod with a hammer.
1/4" DOWEL
\
5, To remove cup center insert a 1/4" wood dowel or
brass rod through hole in taitstock as shown. Hold
center with one hand and tap dowel or rod with a
hammer.
\
21