Craftsman 113.228360 Owner's Manual page 12

9. From theloose parts bag locate a 114"x 1 -1/2" h ex
head bolt,1/4"fiatwasher, 1/4"Iockwasher, and
114" hexnut,Place bolt t hrough c enter b edmount-
ingbracket anddown through d rilled holein the
workbench. Place fiat
washer,Iockwasher, and hex
nut onto bolt from underside of table and tighten.
ILLUSTRATION SHOWS
REAR OF LATHE
LOCK WASHER
HEX NUT
10. Place the edge of a straight edge (at least twelve
inches long) on top of bed sections. Position
straight edge so it overlaps eac_ section of the bed
equally. (See illustration,)
STRAIGHT
EDGE
/
ill=ill ii ii ill i| illll i i
STRAIGHT
EDGE ----.-_.._..__...__..
I1, Kneel down in front of workbench so straight edge
is at eye level. Position your hands as shown in
ilJustration so you can move bed sections up or
down while holding straight edge in position.
12