Craftsman 113.228360 Owner's Manual page 18

3, Place a 5/32 °' hex wrench through round opening
near power cord on backside of headstock. Insert
hex wrench into set screw located 1-1/2" inside
round opening. Tighten set screw securely using
pliers on the end of the hex wrench.
Check to see that headstock is securely attached
to lathe bed by rocking the headstock assembly
from left to right, and also up and down. If any
looseness is detected retighten the set screw.
WARNING: Failure to tighten this set screw
securely may allow headstock to move during
use. This could allow a spindle turning to come
loose, fly out, and cause injury to the operator,
/
HEX WRENCH
MOTOR COVER
4, Remove motor cover from headstock by placing
yeur right and left hand, as illustrated,and pushing
cover to the left.
5, Using a 1/8" hex-L wrench loosen the spindle pulley
set screw, Slide the spindle pufley to the left and
lookbehind the pulley to locate the flatened section
on the spindle. The spindle pulley set screw must
be aligned with and screwed down against the flat
section on the spindle when completing step 6,
PULLEY
SPINDLE
FLAT AREA
SPINDLE
PULLEY
TOWARD MOTOR
18