Craftsman 139.53989 Owner's Manual page 25

ONE-PIECE D OORS
Please readandcomply withthewarnings and
reinforcement instructions on theprevious page.
Theyapplytoone-piece d oorsalso.
• Center t hedoorbracket o nthetopofthedoor,in
linewiththeheaderbracket a s shown. M arkeither
theleftandright,or thetopandbottom holes.
• Drill5/16"pilotholes andfasten the bracket w ith
hardware s upplied.
If thedoorhasnoexposed framing, d rill3/16"pilot
holesandfastenthebracket w ith5/16"x1-1/2" lag
screws (notprovided) t othetopof thedoor.
NOTE: The door bracket may be installed on the top
edge of the door ff required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 Lockwasher 5/16"
Carriage Bott
5/16"-18x2-1/2"
Header WalI
2x4 Support --Finished Ceiling--
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc)
(not provided).
Door
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" Iag screws (not provided)
to fasten door bracket.
Lock
Washer
' 5/16"
J
Top of Door
(Inside Garac
Top Edge
of Door
OptionaI
PIacement
Carriage Bolt
5/16"-18x2-1/2"
25