Bosch Nexxt DLX Operating & Installation Instructions Manual page 26

Fault
Water cannot be seen in
drum.
Indicator light "rinse" is lit
and display is flashing
"E:04" with no water re-
maining in tub.
Water is flowing out from
underneaththe machine.
Suds coming out of the
detergent dispenser.
Repeated spinning.
The laundry was not
spun.
Program duration ex-
tended.
Unsatisfactory washing
result.
Detergent residue on the
laundry.
Gray residue on the laun-
dry.
System shakes or
shudders when passing
from lower to higher
speed spinning.
Possible cause
This is not a fault.
The water level is belowthe visible part of the drum.
Suds or pump is blocked.
The thread of the supply hose is not tight.
Leak in the drain hose.
Too much soap or non-HE soap used, pump could
not remove suds.
This is not a fault.
The imbalance compensation system is attempting to
balancethe load through repeated spins.
Large items of clothing have become entangled and
could not be distributed evenly in the drum. For safe-
ty reasons the high-speed spin cycle was automati-
cally suppressed.
This is not a fault.
The suds detection feature has activated an addi-
tional rinsing cycle to reducethe amount of suds.
This is not a fault.
The imbalance compensation system is attempting to
balancethe load through repeated spins.
The degree of soiling was higher than estimated.
Not enough detergent.
Some phosphate-free detergents contain water-insol-
uble residues that may appear as light spots on the
laundry.
Dirt accumulation from ointments, fats or oils.
Drum system suspension can shift during speed up,
this is not a failure.
Action
Use less detergent for future wash loads. Detergents
specifically designedfor you High Efficientcy washer
produce fewer suds and will include the letters "HE"
on the packaging. Clean the water drainage pipe
and/or drain hose. Turn the program selector to "off"
and restart Drain program.
Tighten the thread.
Replacethe drain hose.
Mix 1 tablespoon of fabric softener with 1 pt (_Alitre)
of water and pour into detergent dispenser Itl.
Use less detergent for future wash loads. Detergents
specifically designedfor you High Efficientcy washer
produce fewer suds and will include the letters "HE"
on the packaging.
Always load the drum with large and small items
together.
Always load the drum with large and small items
together.
Add a more appropriate amount of detergent.
Always load the drum with large and small items
together.
Select suitable program
or
Power Wash as an additional option.
Add detergent according to the manufacturer's
specifications.
Brush off spots when laundry is dry.
Add the maximum amount of detergent and select
the highest permissible temperature.
Mix small and large laundry pieces in load to
minimize this effect.
If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the
appliance on again, select and start the program.
If the fault continues, call customer service; see Page 27.
26