Table of Contents
Advertisement
Remote Control
12. MUTE -- For a Zenith
TV or other brand you
have programmed
the remote
to operate,
press to
turn the sound coming
from your TV off, press
again to restore
the sound.
13. SEQ -- Some Zenith
TVs have audio circuits
that will be operated
with this key.
14. SEARCH
-- Use to advance
or rewind a
recorded
tape to an indexed
position.
15. TVNCR
-- A change key. Press to change
be-
tween TV and VCR tuners
to show broadcast
programs
on the TV screen.
16. TIMER
-- Press when all program
recording
information
has been entered.
This will turn off
the VCR until the program
time arrives.
(After
the program
has been recorded,
press again to
release
VCR from Timer
Mode.)
Note: Once the
VCR is in the Timer Mode the TIMER key must
be pressed to release
the VCR from Timer Mode.
17. F FWD -- Press to advance tape.
18. PAUSE
-- Press to momentarily
cease VCR
record functions
or to obtain
a still picture while
playing a tape.
19. PLAY -- Press to begin playing a tape.
20. STOP -- Press to stop playing or recording
a
tape.
21. REW -- Press to rewind tape.
22. RECORD
-- Press and hold down until
REC CH and the channel
number
you are record-
ing appear
in the VCR message
center
to start
recording
on a tape.
23. MEMORY -- Use with the tape counter
to ac-
cess locations
on recorded
tapes.
24. AM/PM
-- Use to enter AM or PM where
re-
quired.
25. LEARN -- Other
product's
codes can be
learned
by this remote
control;
use the numbered
buttons
and this key to enter the information
necessary
to program
the MBR3429
remote
to
operate
your cable box and TV set.
2613-0
..
26. VCR PLUS -- Press to display the VCR Plus
Code information
on the TV screen.
27. CH MAP -- Press to begin Channel Mapping
procedure
or to review Channel Mapped data.
28. ENTER -- Press to set entered information.
29. Numbers
0 through 9-- Use these keys to
choose information where applicable. These keys
are also used for direct channel access.
Remote
Control Battery Compartment
2.
30. SELECT -- Use this key to choose information
in the menus and sub-menus,
where required.
31. ADd -- Press to choose information
where
ap-
plicable;
also used to manually
adjust the tracking.
1. Open battery
compartment
on the back of the
remote
control
by using your fingernail
to
squeeze
the tab lock open.
2. Lift compartment
door out and install batteries.
Install two (2) high quality new alkaline
AAA
size batteries
in the VCR remote
control.
Note the positive and negative positions
for plac-
ing the batteries
in the remote control. Once
fresh batteries
are installed
into the remote con-
trol it is ready for use.
3. Replace
compartment
door on remote control.
Notes:
Be careful not to place heavy objects
on top of
the remote
control
buttons.
Prolonged
accidental
operation
of the remote
control
will shorten
bat-
tery life.
If you do not use the remote
control
for a month
or more, remove
the batteries.
Battery
leakage
can cause damage
to the remote
control.
Zenith
is not responsible
for damage
caused by
such battery
leakage.
2
Advertisement
Table of Contents
