Setup Menu; Auto Ch. Search - Zenith Sentry 2 SLS1935W Operating Manual & Warranty

• SETUP MENU _
I AUTO CH. SEARCH 1
PRESS ADJUST
KEY TO START
Auto Ch. Search
Display
(_-> AUtO CH. SEARCH
[ CH. ADD/DEL
[ TUNING BAND
[ AUTO FINE TUNE
[ CLOCK SET
k,, . CAPTIONS
j
I
I I
CH2 TUNING BAND
ADDED BROADCAST
PRESS ADJUST PRESS ADJUST
KEY TO CHANGE KEY TO CHANGE
Ch. Add/Del Display Tuning Band Display
I
I CAPTIONS
OFF
PRESS ADJUST
KEY TO CHANGE
Captions Display
I I
i os I i o 1
PRESS NUMBERS P_ ADJUST
OR ADJUST KEYS KEY TO CHANGE
Clock Set Display Auto Fine Tune
Display
AUTO CH. (Channel) SEARCH
Purpose
Finds all available channels and stores them in memory for
access by CHANNEL (CH) Up/Down.
Use AUTO CH. SEARCH only when you first install your
TV, or when you permanently change the connections to
the TV. For example, when you replace the antenna with a
cable-TV system.
Programmed channels are stored in protected memory, and
are not affected by a power outage.
-- > AUTO CH. SEARCH
CH. ADD/DEL
TUNING BAND
AUTO FINE TUNE
CLOCK SET
CAPTIONS
Selecting Auto Ch.
SEARCHING FOR CHANNELS
While Searching for
Active Channels
2573-A
AUTO CH. SEARCH
PRESS ADJUST
KEY TO START
Auto Ch. Search Display
ALrFO CH.SEARCH HAS COMPLETEE
TUNING BAND 1S
D CHANNELS FOUND
When Search is
Complete
Before Using AUTO CH. SEARCH
Connect and turn ON all external equipment, such as cable
TV decoder, VCR, etc.
To Use AUTO SEARCH
1. AUTO CH. SEARCH display should be shown on
the TV if you followed the "Basic Menu Operation"
given in the "On-Screen Menus" section.
2. Press ADJUST (ADJ) Left/Right to start the
AUTO CH. SEARCH, the status of the search is
shown in the display. When the search is complete,
you can watch the TV program of your choice.
When Some Channels Are Not Found
AUTO CH. SEARCH finds only active channels and stores
them in the favorite channel memory. You can add channels to
those stored in memory by using the CH. ADD/DEL option.
If you have difficulty tuning some channels, you may have to
manually change the TUNING BAND and AUTO FINE
TUNE. Refer to respective option for details.
When Only AUX Channel Is Found
You may have used AUTO CH. SEARCH without having a
signal source (antenna, cable-TV, etc...) connected to the TV.
In which case, no channels are stored in the favorite channel
memory, and the TV operates only on the AUX channel.
To resolve this condition, connect a signal source, turn signal
source ON, if needed, and use AUTO CH. SEARCH again.
NOTE: AUX (Auxiliary) channel is operational only on TVs
having separate video and audio inputs for VCR operations.
9-1