Zenith Z36H32 Operating Manual & Warranty page 26

GET TO KNOW YOUR REMOTE (MBR3457)
I I
PROGRAMMING YoUR REMOTE
If you're using Zenith products, the remote is already programmed for the most common codes: TV := I01, VCR = 201, CABLE =
.";53,and AUX = 401. For other brands, or if your remote fails to congo[ your Zenith products, you'lL have to progntm the remote.
Step-By-Step Instructions Response On Remote
I. Install the batteries if you have not already done so.
2. Press and hold O using a blunt object. Indicator light stays on to show you're in the programming
Release PRG after the indicator light turns on. mode.
3. Press then release the Indicator light flashes to show remote is ready to accept
button for the product _ @ Q_ Q_ a code.
being programmed.
4. Indicator light flashes for each digit you enter.
Enter 3-digit @ @ @
product code @ @ (_)
from the chart @ @ (_)
on the next page. @ @
Press then release @ to save the code. Indicator light on remote flashes and turns offto show your
code was accepted.
6. Point re:mote at product and press (_ to test the
I product's operation. If it does not turn on, reprogram the
remote using a different code listed for your product.
Product turns On.
If none of the codes listed for your product operates it,
use Auto Find as describe,:t below.
7. Repeat the above steps to program the remote for another product.