Installation; Ii. Installation; Order Of Installation; Tools Required - Woodstock Shop Fox Fence W1410 Operating Manual

SECTION II: INSTALLATION
A. ORDER OF INSTALLATION
Installation of the Shop Fox
easy. Installation involves mounting the front and
back rails to your table saw and then attaching
the fence to the rails. On some saws, the mount-
ing holes for the rails will match the existing rail
mounting holes. On other saws where the mount-
ing holes do not line up, it will be necessary to
drill and tap new mounting holes in your table top
edge. We've supplied you with a drill and tap for
this purpose. If you are uncomfortable with the
tapping process, through-bolting may be used as
an alternative. If through-bolting, make sure you
have access to the backside of the hole and that the
table webbing will not interfere with the nut and
bolt before attempting this method.
Before beginning installation, measure your table
saw top from front to back. The Shop Fox
comes preset to fit on tables measuring between
26 ⁄ '' and 27 ⁄ ''. If your table top is not within
5 1
8 4
this range, refer to the Troubleshooting Guide for
further instruction.
B. TOOLS REQUIRED
Only a few common tools are required to assemble
your Shop Fox Fence. Specifically, these are:
®
14mm open end wrench
5mm Allen wrench
3mm Allen wrench
Regular screwdriver
6" adjustable wrench
Needle nose pliers
⁄ '' socket and ratchet
7
16
Optional Tools:
⁄ ''-16 tap
3
8
⁄ '' drill bit
5
16
⁄ '' drill bit
1
8
⁄ '' or ⁄
3 1
8
Center punch
Hammer
Tap handle
Shop Fox Fence
®
Fence is quick and
®
Fence
®
'' Electric drill
2
C. MOUNTING THE RAILS
Step 1.
Locate the back fence rail (the rail with the oval
cut-outs) and set it against the rear edge of the
table saw. Position the back rail so that its top
edge is ⁄ " below the table top and the oval cut-
1
16
outs are in line with the miter slots. Figure 1. If the
back rail mounting holes line up with the existing
holes in the table top, attach the rail using the
original mounting hardware as shown in Figure
3. If the holes do not line up, use the mounting
method covered in Steps 3-6.
Figure 1. Attaching the back rail.
Step 2.
Line up the ends of the front rail even with the
back. Set the top edge
the miter slots. Figure 2. If the front rail mounting
holes line up with the existing holes in the table
top, attach the rail using the original mounting
hardware as shown in Figure 3. If the holes do
not line up, use the mounting method covered in
Steps 3-6. If both rails are mounted at this point,
skip to Step 7.
Note: Delay installation of the adhesive scale
(#56) until Section III Part G.
⁄ " below the bottom of
1
16
-5-