Selecting Digital Audio Output - Zenith IQDVD2300 Operating Manual

PAGE 40 I INITIAL SETUP OPERATION
Selecting Digital Audio Output
Select the digital output to be output from the
coaxial digital audio output connector of the
unit,
At the SETUP screen.
B Press J_J?' t o select Digital Audio Output and
press I_.
u
ooo
ooo
ooo©
0o0©
Playback
Disc
OUTPUT
0ofby 0iCtav
PCM
48 kHz, 16 bit
Linear PCM
48 kHz, 20 blt
Lklear PCM
Stream/PCM
48 kHz, 16 bit
unear PCM
48 kHz, 20 bit
Unear PCM
Not Output
DTS bit Stream
Dc_by Dig_
bit Stream
MPEG bit Stream
44.1 kH_ 16 t_t
Linear PCM
DTS bit Stream
PCM only
48kHz, 16 b_t 48 kHz, 16 bit
PCM CVC Unear PCM
48kHz, 20/24 bit 48 Id-lz, 20 bit
PCM DVD Linear FCM
96 kHz
Linear PCM Not Output Not Output
DVD
DTS CVD Not Output Not Output
Dolby Digital Dolby Digital 48 kHz, 16 bit
DYD bit Stream PCM
MPEG DVD 48 kHz, 16 bit 48 kP,z, 16 bit
Linear PCM Linear PCM
Audio CO 44.1 kHz, 16 bit 44.1 kHz, 16 bit
Litwar PCM LJne_ PCM
DTS Audio CD DTS bit Stmatn DTS bit Stream
DOLBY DIGITAL/PCM: Select =DOLBY DIGITAL/PCM" if
an active digital output is supplied to dolby
digital decoder, (or an amplifier or other equipment with dolby
digitaJdecoder).
Stream/PCM: Select "Stream/PCM" if an active
digital output is supplied to an amplifier or other
equipment with DTS decoder, dolby digital decoder and
MPEG decoder.
PCM: Select "PCM" if an active digital output is
supplied to an amplifier or other equipment with linear PCM
only (or MD recorder or DAT deck).
• When you are not using the player's digital audio output, don't
select any of the options.
• If an active digital audio output s_gnal is supplied to an receiver or
other equipment without a corresponding digital decoding capabil-
ity, a very loud noise may be produced which could permanentJy
damage the speakers.