Vcr Status Displays; Vcr Status Display Operation; Vcr Status Display Options - Zenith VR4106 Operation Manual & Warranty

FRONT PANEL CONTROLS AND DISPLAYS
VCR Status Displays
Current mode of operation
(STOP, PAUSE, REC, PLAY, etc.)
and
Audio format of tape, where
Play = HI-FI or NORMAL
Record = STEREO, MONO or 2nd AUD
Tape Speed, where
EP = Extended Play
LP = Long Play
SP = Standard Play
Current date, day, and time
...........
SP ST/2nd AUD--
15 MON
7:17 AM M-01:35:45 --
Typical VCR Status Display
Shown on TV
Current CH (Channel) selected
by using tuner in VCR
Audio format of signal being
received by VCR tuner:
STEREO, MONO or ST/2nd AUD
Status of real-time tape counter
M = Counter Memory is active
- = Tape is rewound past index mark
01:35:45 = Tape position in time
01 = 1 hour
35 = 35 minutes
45 = 45 seconds
M-01:35:4. _
J
Display Showing
Tape Counter Position
REM 1:35
J
Display Showing
Tape Time Remaining
VCR Status Display Operation
The VCR Status Display appears on the TV when a VCR
function starts, like changing a channel or selecting a differ-
ent VCR mode. For example, pressing STOP while the VCR
is in PLAY mode shows STOP in the display. You can press
ENTER on the remote control any time to see the Status
Display.
NOTE: If the VCR Status Display does not appear on the
TV screen, check the status of the ON-SCREEN DISPLAY
option on the SETUP menu. Select ON Status to see the
display. Refer to the "VCR Menu Operations'section for
details.
VCR Status Display Options
When the Status Display is shown, you can press ENTER
repeatedly to see abbreviated displays, as follows:
1.
Press ENTER to see Status Display.
2. Press ENTER a second time to show only the tape
counter position.
3. Press ENTER a third time to show only the tape time
remaining.
4. Press ENTER repeatedly until all displays are removed.
13