Epson Stylus Color 640 Service Manual page 139

EPSON Stylus Color 440/640/740
5.2.2.2.2 Setting the CG (Destination information)
Color 740 only)
Since there are two models for Stylus Color 740, the standard model
and NLSP model, you are required to set the correct CG according to
the model by following the steps described in this section.
1. (For Stylus Color 740 only)
Select "No" on the Initial Screen (2) (Figure 5-7), and the screen
below appears.
Figure 5-11. Destination Setting Screen for Stylus Color 740
Chapter 5 Adjustment
(For Stylus 2. (For Stylus Color 740 only)
Perform one of the followings:


If your Stylus Color 740 supports the NLSP characters, select
NLSP by using the reverse carols. Be sure to perform this
operation because a spare C257 Main board has the CG set to
Standard at factory.


If your Stylus Color 740 does not support the NLSP characters,
select Standard.
The program automatically returns to the Initial Screen (2) (Figure 5-7)
after a few seconds.
The CG value has been correctly set. Return to
5.2.2.2 / Step 6 to enter the main menu.
Do not select the NLSP if your Stylus Color 740 does
not support the NLSP characters. You can distinguish
the NLSP model from Standard model by referring to
the following point on the C257 Main board;


Standard: There is no IC6 on C257 Main board.


NLSP: There is IC6 on C257 Main board.
Revision A
Section
139