Panasonic Viera TC-L37X2 Operating Instructions Manual page 7

First Time Setup
First time setup screen is displayed only when the TV is turned on for the first time after the power cord is
inserted into a walt outlet and when "Auto power on" (p. 29) is set to "No".
Turn the TV On with the POWER button
(TV) (Remote)
POWER
or
Configure your viewing mode
Select your language
Select your viewing mode (Be sure to select "Home use")
® Please confirm your selection (Home Use) before pressing OK button.
• If you select "Store Demonstration" by mistake in (_,
confirmation screen will be displayed,
® Select "No" and return to previous screen _2>.
® If you select "Yes", Screen enters the store demonstration mode.
To display the "Set viewing mode" screen again as shown above and select
"Home Use", do one of the following:
• Press and hold down the side POWER button for at least five seconds.
• Unplug power cord for 30 seconds and plug it again.
RETURN
® _ is not available on _ - _,
® _ is not available on _.
® When you have used _ to turn the TV off, the next time you turn the TV on the
"Language" settings will be displayed.
® If you use any other step other than _ to turn the TV off, or if you used the EXIT
button to quit before completing the settings, the next time you turn the TV on "First
time setup" will not be automatically displayed.
• The settings up to that point are saved.
• You can reset the settings using "First time setup". (p. 29)
® To change the setting (Language, ANT/Cable setup, Input labels, Clock) later, go to
the Menu screen (p. 29)
• Press to return to
the previous screen
RETURN
@
Auto channel setup (ANT/Cable setup)
_> Select the connected Antenna in terminal
Not used: Go to
(Labet inputs)
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
® Typical when a Cable/Satellite box is connected to a TV input.
® Prevents accidental tuning to an unavailable signal.
Select "Start"
Skip: Go to
(Label inputs)
Start scanning the channels
(Availablechannels are automatically set.)
Complete the Auto program setup
Completion message is displayed when the Auto program scan is successfully
completed.
If there is no available
OK channel, return to O - _1_
(ANT! Cable setup).
"Not used" will be selected.
• Operation of the EXIT button during "First time setup"
Press the button once to display confirmation screen. Press again to close
confirmation screen.
[EXIT confirmation screen]
Yes @ Exit "First time setup"
No _ Return to the original screen.
@
77
-4
3
(D
03
(D
t-
12 13