Tv/Video Button; Recall Button; R-Tune (Rapid Tune) Button; Multi Button - Panasonic PV-M2044 Operating Instructions Manual

TV/Video
- Press the 1 V/VIDEO button to select
desired input.
TV/VIDEO
Signal connected to:
REAR VIDEO/AUDIO INPUT 2 JACKS
/
REAR VIDEO/AUDIO _ INPUT 1 JACKS
TV or CABLE
VIDEO 2 I
VIDEOll I
CH 02 7
Recall
- Press the RECALL button to review:
• Audio Mode status
• CH number or Video Input selected
• Sleep Timer status
• Clock time
• Channel Caption (Station Identifier)
RECALL
STEREO : VIDE.O.1,
SAP CH 03
MONO XYYZ
29 1:00
R-Tune (Rapid Tune) - Press theR-TUNE
(RAPID TUNE) button to instantly switch between the
last two channels selected (without any On Screen
display being activated).
R-TUNE
CHANNEL NOW CHANNEL TUNED
BEING VIEWED IMMEDIATELY BEFORE oj ress u't°n'
"__.-.-.%_. _Press Button Again
-9-
Multi Button
The MULTI button can be programmed to operate
up to 6 Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On (selected
brands) can be operated at the same time with one
press of the MULTI button.
PROCEDURE
1. First program the Remote for the selected VCR
Infra-red access code. Confirm that the Remote
Control is compatible with the equipment.
2. Face the Remote Control transmitter away from all
equipment remote sensors.
3. Press the Remote TV POWER button and the
MULTI button simultaneously. (All previous
commands are erased.)
(TV)
POWER MULTI
PRESS SIMULTANEOUSLY
4. Press a maximum of 6 Function buttons on the
Remote.
Each button you press is equal to one function. If six
remote button functions are entered, all will register
in the MULTI button memory in the sequence
entered. When less than six remote button
functions are entered, press the MULTI button to
end the program mode. (Waiting more than 30
seconds without pressing another button will also
end the program mode.)
The following is an example of Remote functions
that can be programmed into the MULTI button.
- TV Power- For turning TV ON and OFF.
- VCR Power - For turning VCR ON and OFF
(selected brands after programming it's Infra-red
access code, if necessary).
Both can be turned ON or OFF with one press of the
MULTI button.
(TV)
POWER VCR
POWER MULTI
To delete entered functions- Press the Remote
TV POWER and MULTI buttons simultaneously.
Now you can enter from one to six different
Remote functions. (TV)
POWER MULTI
PRESS SIMULTANEOUSLY
NOTE:
You can also program the MULTI button to
perform most individual Remote Control button
functions. Buttons which continuously perform a
function as long as pressed (Volume Up/Down,
Channel Up/Down, etc.) cannot be programmed.
Only those buttons which perform a function when
initially pressed (Power On/Off, Mute, Direct
Channel Entry, etc.) can be programmed.