Tv/Video Button; Recall Button; R-Tune (Rapid Tune) Button; Multi Button - Panasonic CT-32G21 Operating Instructions Manual

TV/Video Button
- Press the TVNIDEO button
to select desired input for Main Picture or PIP frame
(when the PIP is displayed).
Signal connected to: I,J,
REAR VIDEO/AUDIO INPUT 2 JACKS _1 VIDEO 2 I
REAR VIDEO/AUDIO
_ iviD_0;;_;' I
I
INPUt 1 JACKS I
TVor CABLE -_ : CH02 I / I
[
Signal connected to:
REAR V,DEO/AUO,O,NPUT2JACKS---fl P,PV, OEO 2I
REAR VIDEO/AUDIO _ / PIP VIDEO il I I
INPUT 1 JACKS I . _.LI
TVorCABLE _ : :PIP_
/
l P,PFrame
Recall Button
- Press the RECALL button to
review:
[] Audio Mode status
[] CH number or Video Input selected
[] Sleep Timer status
[] Clock time
[] Channel Caption (Station Identifier)
[]
[]
[]
[]
[]
R-Tune Button
- Pressing the R-TUNE (RAPID
TUNE) button will switch between the last two channels
selected on the numeric keypad.
NOTE: When rapidly scanning channels with the
CHANNEL UP/DOWN button, pressing the
(_ R-TUNE button will switch between the last
:channel scanned, and initial channel at the start
of scanning,
.i ::i :_ : :::: : : ......
CHANNEL NOW CHANNEL
BEING VIEWED PREVIOUSLY VIEWED
Press Button _I Press Button Again
t
Multi Button
The MULTI button can be programmed to operate
up to 6 Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On and
Cable box Power/On (selected brands) can be operated
at the same time with one press of the MULTI button.
Procedure
1. First program the Remote for the selected device
Infrared access code. Confirm that the Remote
Control is compatible with the equipment.
2. Face the Remote Control transmitter away from all
equipment remote sensors.
3. Press and hold the Remote POWER button, then
press and hold the ACTION button down at the
same time for three seconds. (All previous
commands are erased.) ,.__
PRESS ATTHE SAMETIME "--_
FOR THREE SECONDS L-_
4. After three seconds, let go of the POWER and
ACTION buttons.
5. Press the MULTI button.(Waiting more than 30
seconds withoutpressing another button willexit the
programming mode.)
6. Press a maximum of 6 Function buttons on the
Remote.
Each button you press is equal to one function. If six
Remote button functions are entered, all willregister
in the MULTI button memory in the sequence
entered. When finished, press the MULTI button to
end the program mode.
The following is an example flow chart of Remote
functions that can be programmed into the MULTI
button (The VCR Mode button should be
programmed before starting procedure see pg. 29).
E PRESS PRESS |
FOR THREE SECONDS /
PRESS PRESS PRESS TO END
PROGRAM MODE
Now you can turn the TV and VCR ON/OFF at the
same time with one press of the MULTI button.
To delete entered functions - Press and hold the
Remote POWER button then press and hold the
ACTION button down at the same time for three
seconds. Now you can enter from one to six diffe rent
Remote functions.
NOTE:
:_m6st individua Re.re Go_troi b_tt0n fun_i0ns;
long as pressed (Vo|_me Up/Down
i Up/Down i etc!)cannot belprogrammed Only those
: b_ttons which perfo functioh when nitially
-15-