Built-in well modular warmers with infinite, thermostat or digital controls (40 pages)
Summary of Contents for Wells TCW-Series
Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
(775) 689-5707 or fax (775) 689-5976 if service is performed by unauthorized personnel. The prices charged by Wells Bloomfield for its products are for information and other details concerning warranty. SERVICE POLICY AND PROCEDURE GUIDE and ADDITIONAL WARRANTY EXCLUSIONS Resetting of safety thermostats, circuit breakers, over cleaning schedules, are customer responsibility.
PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Bloomfield appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
Do not operate this appliance if the control panel is damaged. Do not followed. operate this appliance if the keypad section of the control panel is torn or broken. Call your Authorized Wells Service Agent for service. CAUTION: The technical content of this manual, including any wiring diagrams,...
INSTALLATION NOTE: DO NOT discard UNPACKING & INSPECTION the carton or other packing Carefully remove the appliance from the carton. Remove all materials until you have protective plastic film, packing materials and accessories from the inspected the appliance for appliance before connecting electrical power or otherwise performing hidden damage and tested it any installation procedure.
Page 7
INSTALLATION (continued) ELECTRICAL WARNING: ELECTRIC Refer to electrical specifications on page 1. Circuit must meet or exceed the amperage and wattage requirements listed. SHOCK HAZARD All servicing requiring 120 Volt units require a properly grounded NEMA 5-15R receptacle: access to non-insulated elec- trical components must be performed by a factory au- thorized...
OPERATION OPERATION CAUTION: HOT SURFACE TCW- and TCWN- warmers are designed for holding dry, crispy product at temperature. Do not use this unit for wet or moist operation. Exposed surfaces can be hot to the touch and may cause Humidity control vent should be OPEN. burns.
Page 9
CLEANING PRECAUTIONS: Press power switch to OFF. CAUTION: Allow drawer(s) to cool before proceeding. HOT SURFACE Remove drawer pan(s) FREQUENCY: Minimum - Weekly Exposed surfaces can be hot TOOLS: Warm water and mild detergent to the touch and may cause Clean cloth or sponge burns.
Reset circuit breaker No lights or heat Allow unit to cool until overload (all drawers) Internal overload tripped automatically resets Contact an Authorized Wells Internal damage Service Agency for repairs Temperature control not set Set for desired temperature. No heat (one drawer)
KIT, CASTERS (SET OF 4) 21947 For factory authorized service, or to order factory authorized replacement parts, contact your Wells authorized service agency, or call: Wells Bloomfield, LLC 2 Erik Circle P. O. Box 280 Verdi, NV 89439 Service Parts Dept.
Page 12
Commercial Food Equipment Service Association Wells Bloomfield proudly supports CFESA Commercial Food Equipment Service Association SERVICE TRAINING - QUALITY SERVICE SERVICE TRAINING - QUALITY SERVICE Genuine Parts Protect - YOU - All - Ways CUSTOMER SATISFACTION CUSTOMER SATISFACTION WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P.
Need help?
Do you have a question about the TCW-Series and is the answer not in the manual?
Questions and answers