Connecting A Satellite Receiver - Sony KLV-23HR1 Operating Instructions Manual

hr_s_a_[ ng and ConnectingtheIV
Connecting a Satellite Receiver
Disconnect all power sources before making any connections.
1
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
2 Using AUDIO and S V1DEO cables, connect the satellite receiver's AUDIO
and S VIDEO OUT jacks to the TV's AUDIO and S V1DEO IN jacks.
3 Connect the supplied 75-ohm coaxiat cabte from your cable or antenna to the
TV's VHF/UHF jack.
Rear of TV
75-ohm _,
coaxial
cable
(supplied)
AUDIO-R (red) ____
AUDIO-L (white) __.2_J
VIDEO (yellow) _-_
Satellite receiver
-- S VIDEO ',_r-_HF _'_ 1
I. _[_ U..OUT_ @ / Satellite
_]_ _ / ant_n na
(not supplied) "" I _
L
YC-15V/30V (not supplied)
Note
To watch the pictures input from the S VIDEO input jack, set "Auto YC" to "On" in the
(Setup) menu (See page 12).
Tips
• YOU can also use the VIDEO 2 IN jacks on the fi'ont panel of the TV to connect your
satellite receiver.
• If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
13