Connecting A Satellite Receiver - Sony WEGA KLV-26HG2 Operating Instructions Manual

Ii"_stalling ad Col"_ ect ng t_e TV
Connecting a Satellite Receiver
Disconnect all power sources before making any connections.
1
2
Tip
Connect the satellite antenna cable to the satellite receiver's SATELLITE
IN jack.
Using AUDIO and S VIDEO cables, connect the satellite receiver' s AUDIO
and S VIDEO OUT.jacks to the TV's AUDIO and S VIDEO IN ;jacks.
• If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
3
Connect the supplied 75-ohm coaxial cable from your cable or antenna to the
TV's VHF/UHF jack.
Rear of TV
Satellite receiver
cable
S VIDEO cable
(not supplied)
75-ohm coaxial 3
cable
S
AUDIO-L (white)
AUDIO cable (not supplied)
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
,, ,,
"Auto YC ' in the _ (Setup) menu is set to "On to view the S VIDEO input (see
sure
page
12).
Tips
• You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your
satellite receiver.
• Use TViVIDEO on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV or to watch a tape on the VCR
(your VCR must be turned on).
13