Thumb Wheel Adjustment; Inlet Water/Steam Strainer - Vulcan-Hart C24GA6 ML-136021 Service Manual

C24GA SERIES CONVECTION STEAMERS - SERVICE PROCEDURES AND ADJUSTMENTS

Thumb Wheel Adjustment

The thumb wheel directly below the microswitch
changes both the cut-out (off) and the cut-in (on)
points of the operating Pressure Switch.
Turn the thumb wheel to obtain the proper cut-out (off)
setting. Turning thumb wheel clockwise increases the
pressure. The cut-out (off) off setting should be 3.5 to
4 psi.
F35425 (February 2006)

Inlet Water/Steam Strainer

1. Unscrew the cap from the body.
2. Remove the screen and any foreign particles
trapped in the opening.
3. Rinse the screen thoroughly to remove
accumulated debris and replace the screen in
the valve body. If the screen cannot be
thoroughly cleaned, replace it with a new one.
4. Reinstall the cap.
Page 16 of 40