Antenna Hookups; Audio Component Hookups - Sony STR-D360Z Operating Instructions Manual

Antenna Hookups
Overview
This section describes how to connect AM and FM
antennas to the receiver. If you want to receive radio
broadcasts with the receiver, complete these
connections first, then go to the following pages.
For specific locations of the terminals, see the
illustration below.
ANTENNA
What antennas will I need?
• FM wire antenna
(supplied) (1)
Hookups.
• US model
FM wire antenna
• AM loop antenna
(supplied) (1)
Receiver AM loop antenna
"_1 If you have poor AM reception
Connect a 20 to 50 ft. (6 to 15-meter) insulated wire (not
supplied) to the AM antenna terminal in addition to the
AM loop antenna. Try to extend the wire outdoors and
keep it horizontal.
Connecting a ground wire
To prevent hum, connect a ground wire (not supplied)
to the _a ground terminal. If you've connected an
outdoor antenna, be sure to connect the ground for
lightning protection.
• US models
Receiver
ANTENNA
I
4
to ground
• Australian models
Receiver
I
to ground
Where do I go next?
If you want to connect other components, go on to the next
section. If you're only planning to use the receiver to listen
to the radio, go to "Speaker System Hookups" on pages 6
and 7.
After connecting
the wire
antenna, keep it
as horizontal as
possible.
• Australian model
FM wire antenna Receiver AM loop antenna
After connecting
the wire aerial,
keep it as
horizontal as
possible.
"_° If you have poor FM reception
Connect a 75-ohm coaxial cable (not supplied) to an FM
outdoor antenna. ",_ull back the mesh portion
surrounding the inner cable and connect it to the earth
terminal (right side). Connect the inner cable to the FM
terminal (left side).
• US model * Australian model
Receiver Receiver
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
For specific locations of the jacks, see the illustration
CD
I
I
PHONO TAPE/MD
(Except STR-DE315(US))
What cords will I need?
Audio cords(not supplied) (1 for eachCD player or
turntable; 2 for eachtape deckor MD recorder)
White (L)_ White (L)
Red (R) _ _ Red (R)
(continued)
5