Sony STR-D360Z Operating Instructions Manual page 10

10
Operatingone componentwhile using
another(BackgroundOperation)
You can temporality operate other components while
listening to or watching a program.
Numeric buttons
BACKGROUND
ooo
ooo
ooo
r_l r_l r--1
k-_ r-_l r---7
.r-_ r-_ r-_
czl r-_ ci]
c:D c!:_ c::_
1
Hold down BACKGROUND.
2
Press both the corresponding numeric button of
the component you're going to use (see the table
below) and one of the following buttons at the
same time; VISUAL POWER, TV/VIDEO, CH
PRESET +/-, ANT TV/VTR, D.SKIP, D..-, -91, m,
_1_1 / I_1_, I_1_1 / I_H, I I, O.
Example:To start recording on a tape deck while
listening to a CD
While holding down BACKGROUND,
press 4 (or 5) and press • at the same
time.
The numeric buttons are assigned to select the
functions as follows:
Numeric button Operates
1 CD player
2 DAT deck
3 MD deck
4 Tape deck A
5 Tape deck B
6 LD player
7 VCR (remote control mode VTR l*)
8 VCR (remote control mode VTR 2*)
9 VCR (remote control mode VTR 3*)
0 TV
>10 DBS
•Enter DVD
* Sony VCRs are operated with a VTR 1, 2 or 3 setting.
These correspond to Beta, 8mm and VHS respectively.
Changing the factorysetting of a
function button
ill
If the factory 'settings of the FUNCTION buttons (page
9) don't match your system components, you can
change them. For example, if you have two CD players
and you don't have a tape deck or an MD recorder,
you can assign the TAPE/MD button to your second
CD player.
Note that the settings of the TUNER and PHONO
buttons cannot be changed.
Numeric buttons
_0
--1 r-7 r--7
-7 r-7 r-7
ooo
ooo
n_n
SYSTEM
CONTROL/
FUNCTION
1
2
Hold down the SYSTEM CONTROL/FUNCTION
button whose function you want to change
(TAPE/MD, for example).
Press the corresponding numeric button of the
component you want to assign to the SYSTEM
CONTROL/FUNCTION button (1 - CD player,
for example).
For ['he numeric buttons, see the table in
"Operating one component while using another"
on this page.
Now you can use the TAPE/MD button to control
a second CD player.
To reset the setting to the factory setting
Repeatthe above procedure.