Table of Contents
Advertisement
SW2-4
Set the form length with this switch. ON is 12 inches; OFF is
11 inches.
When a form feed character is sent by the computer, the paper
moves to the next sheet if the optional cut sheet feeder is
attached, or to the top of the next form if the optional tractor unit
is being used. Set the switch according to the length of the sheets
or forms you are using. The form length can also be changed
temporarily under software control.
SW2-5
Set this switch to ON to automatically skip the perforations in
fanfold paper.
Set this switch to OFF when you want your printing (such as
program printouts) to be continuous and free from breaks caused
by the printer. This switch should also be set to OFF when the
word processing or other software program you are using re-
quires complete control of the page length.
SW2-6
Set this switch to ON when you
buzzer.
Set it to OFF when you want the buzzer to work.
SW2-7
When you want high-speed printing in draft quality, turn the
switch to OFF for a print speed of 176 characters per second.
Set this switch to ON for Letter Quality mode at 105 characters
per second.
SW2-8
Set this switch to ON to enable the printer upon power ap-
plication.
The ON LINE light on the control panel will glow when the
printer and computer are on-line (in communication) when pap-
er has been loaded. If this switch is not set to ON, some applica-
tions software may not operate properly.
Set this switch to OFF to allow the printer to be activated or
deactivated by the computer.
D-8
to disable the printer
want
Advertisement
Table of Contents
