Adjustment - Epson Photo750 Service Manual

EPSON Stylus Photo 750
„ Be sure that the grounding plate is installed to the
carriage correctly. (There are 2 fixing pins on the
carriage.
„ After installing the print head to the carriage, be
sure that the fixing pin at the carriage side is
correctly located into the cut out of the printhead
unit.
Figure 4-8. Print Head Installation
Disassembly and Assembly
„ Install the new cartridge before sending the printer
back to the user, since the ink cartridge once taken
out can not be used again.
„ When you return the printer to the user, pack the
printer in the state that the ink cartridges are
installed in the printer and carriage is in the home
position.
Perform the following adjustment after replacing the
print head.
1. Ink Initial Charge (See "Initial Ink Charge" on
page -88)
2. Head ID Writing (See "Head Voltage ID
Adjustment" on page -83)
3. Head Angular Adjustment (See "Head Angular
Adjustment" on page -84)
Disassembly
Revision A
60