Panasonic SDR-SW20 RED Operating Instructions Manual page 83

This section explains the main messages appearing on the LCD monitor and
how to deal with them.
Message
PLEASE CONNECT
AC ADAPTOR
ERROR
OCCURRED.
PLEASE TURN UNIT
OFF, THEN TURN
ON AGAIN.
DISCONNECT USB
CABLE.
CANNOT OPERATE
WHILE USB
CONNECTED.
CARD ERROR
DETECTED.
NOW REPAIRING
DATA.
DISC IS UNUSABLE.
CHECK DISC.
CANNOT CHECK
CONNECTED
DEVICE.
DISCONNECT THE
USB CABLE FROM
THIS UNIT.
You tried connecting the unit to a computer without
connecting the AC adaptor.
The unit detected an error. Eject the SD card and turn
off the unit and turn back on.
The unit is not properly connected to a computer or
printer.
Disconnect and reconnect the USB cable.
The unit cannot be turned off while it is connected to
a computer.
The data on the SD card contains errors.
To repair the data, either use a battery of sufficient life
or connect the AC adaptor. Depending on the error, it
may take time to repair the data.
The data has been repaired.
● Depending on the situation, the data may not be
completely repaired.
● If the unit is turned off without repairing data, data
can be repaired the next time that the unit is turned
on.
● If repairing fails, the data cannot be played back.
Format the SD card with this unit.
● Do not repair SD cards recorded on other devices
on this unit.
The disc cannot be used or cannot be written on. Use
a new disc.
A device that cannot be used with this unit is
connected to the unit.
What to check
83
VQT1M34