Selecting Fonts - Epson LX-300+ User Manual

Selecting fonts

After entering the micro adjust mode by holding down the Pause
button for three seconds, you can change font settings with the
Tear Off button. The two font lights come on (n) and go off (o)
to show the current selection. Press the button repeatedly to cycle
through all of the available selections; then stop when you reach
the desired font.
Your selection stays in effect until you change it again or turn off
the printer. However, any font choices you make with your
software will cancel your control panel selection. The table below
shows how the Tear Off lights appear for each selection.
Font
EPSON Draft
EPSON Draft condensed
EPSON Roman
EPSON Roman condensed
EPSON Sans Serif
EPSON Sans Serif condensed
n = on o = off f = flashing
2-4
Using the Printer
FONT Sample
Light
1 2
o n
o f
n o
n n
n f
f o