HP StorageWorks D2D Configuration Manual page 46

4. To optionally configure CHAP authentication you should update the iSCSI Authentication details
in the web management GUI, as shown below.
Once the HP StorageWorks D2D Backup System has been modified, the operating system should
be modified as follows:
# iscsiadm modify initiator-node --authentication CHAP
# iscsiadm modify initiator-node --CHAP-name <chap_username>
# iscsiadm modify initiator-node --CHAP-secret
Enter the CHAP password when prompted.
If bi-directional CHAP authentication is required, also perform the following steps:
# iscsiadm modify target-param --bi-directional-authentication enable
<iqn...>
# iscsiadm modify target-param --authentication CHAP <iqn...>
# iscsiadm modify target-param --CHAP-name <chap_username>
# iscsiadm modify target-param --CHAP-secret <iqn...>
Enter the CHAP password when prompted.
5. To configure the iSCSI target devices as static devices, use the following commands:
# iscsiadm add static-config <iqn...>,x.x.x.x
# iscsiadm modify discovery -s enable
# iscsiadm list discovery
Discovery:
Static: enabled
Send Targets: enabled
iSNS: disabled
6. To verify the static configuration, use the following commands:
# iscsiadm list static-config
Static Configuration Target: iqn.1986-
03.com.hp:storage.d2d.cr203f18f4.01a9754150ae013a.library1
.robotics,x.x.x.x:3260
Static Configuration Target: iqn.1986-
03.com.hp:storage.d2d.cr203f18f4.7e0cdac23ab4eab1.library1
.drive,x.x.x.x:3260
# iscsiadm list target
Target: iqn.1986-03.com.hp:storage.d2d.cr203f18f4.7e0cdac23ab4eab1
.library1.drive1
Alias: -
ISID: 4000002a0000
Connections: 1
Target: iqn.1986-
03.com.hp:storage.d2d.cr203f18f4.01a9754150ae013a.library1.robotics
Alias: -
ISID: 4000002a0000
Connections: 1
46 Solaris (x86 and SPARC)