Configuring The Hp Storageworks D2D Backup System For Fibre Channel - HP StorageWorks D2D Configuration Manual

5. To enable the iSCSI target devices to remain persistent across system reboots, the open-iscsi
service must be configured to run at system startup. This can be done by issuing the following
command:
SLES 10
localhost:~ $ chkconfig open-iscsi on
RedHat 5
localhost:~ $ chkconfig iscsi on
6. To verify that this configuration change has been accepted, use the following command:
SLES 10
localhost:~ $ chkconfig –-list open-iscsi
open-iscsi
RedHat 5
localhost:~ $ chkconfig –-list iscsi
iscsi
7. To verify that the Linux machine now has access to the target device, use the following command:
localhost:~ $ cat /proc/scsi/scsi
The output of this command will be a list of all the configured SCSI devices on the system, including
the HP StorageWorks D2D Backup System. An example output would be:
Attached devices:
Host: scsi4
Vendor: HP
Type:
Host: scsi5
Vendor: HP
Type:
Configuring the HP StorageWorks D2D Backup System for
Fibre Channel
For a Switched Fabric Configuration, zone the individual devices to the host concerned using the
virtual device WWNs shown on the GUI.
20 Linux (x86, x64 and IA64)
0:off 1:off
0:off 1:off 2:off
Channel: 00 Id: 00
Model: MSL G3 Series
Medium Changer
Channel: 00 Id: 00
Model: Ultrium 3-SCSI
Sequential-Access
2:off 3:on 4:off
3:on 4:off 5:on
Lun: 00
Rev: pc81
ANSI SCSI revision: 03
Lun: 00
Rev: pc81
ANSI SCSI revision: 03
5:on 6:off
6:off